Moving Walk Drawing© Copyright 2020 La Grazia Srl - All rights reserved

Get a Moving Walk Drawing

In this section, you can get customized moving walk drawings based on your project specifications. You will need to enter the following variables:

  • Height: Height is the difference between two building floor levels which is calculated from the finished surface level of the lower floor to the finished surface level of the upper floor.
  • Angle: Moving Walk Angle can be either 10, 11, or 12 degrees.
  • Step width: Inclined moving walks pallets are usually made in either 800 mm or 1000 mm widths. You can choose either of the widths considering project utilization and requirements.
  • Floor Thickness (FT): Floor thickness is defined as the thickness of the upper floor.

In the next step, you will need to fill the contact information form.

NOTE: The items indicated with * are mandatory to fill.

Project Information

Contact Information

Please enter your email address in the box below. Your customized drawings will be sent to your email address immediately.

NOTE: If you do not receive a response within a few minutes, please check your spam folder for a response in case your email system identified our email as spam.