la grazia escalator and moving walk- Escalator in shopping mall
  • July 1, 2020
  • 2
  • 121
  • 4.0/5

Necessary Information for Ordering an Escalator


Before ordering an escalator, we should have some information about the installation environment and passenger traffic.  

Installation Environment

Based on installation environment, we divide escalators into the following categories, each of which has its own set of options and specifications: • Indoor • Semi Outdoor • Fully Outdoor
Based on project requirements, the customer can select one of the aforementioned options.  

Passenger Traffic

Based on passenger traffic, we divide escalators into the following categories: • Standard Type • Heavy-duty
Based on project requirements, the customer can select one of the aforementioned options.
For ordering an escalator, the customer needs to have the information below.  

Available Elevation Height

The definition of Elevation height is the difference between two building floors. The standard measures the height from the finished surface level of the lower floor to the finished surface level of the upper floor. So, please bear in mind, if you have measured the height before the completion of the flooring, then the flooring level should be the same amount on both floors.

Escalator Angle

Based on standards, Escalators are manufactured in 30-degree and 35-degree configurations. The 30-degree and 35-degree escalators can both be used for elevation heights of up to 6 meters. However, for elevation heights of more than 6 meters, only the 30-degree escalators can be selected. Based on project requirements, the customer can select one of the aforementioned options.

Width Measurements in Escalators

The standard escalator step widths are divided into three categories: • 600 millimeters • 800 millimeters • 1000 millimeters
The total device width corresponding to each of step widths are as below: • 1260 millimeters • 1460 millimeters • 1660 millimeters
Based on project requirements, the customer can select one of the aforementioned options.  

Horizontal Length

Based on elevation height, and after choosing the appropriate angle, following the formula for each angle, the horizontal length will be determined, which is equal to the horizontal spacing between two structural beams.
Take into account the required length in the design phase of the project.  

Ceiling Opening

In order to install an escalator, consider an opening on the upper floor with a suitable width and length. The opening width is equal to the total escalator(s) width and the opening length must be designed in a way that the vertical height between step tread surface and under the available ceiling is never less than 2.30 meters. This vertical height must exist to create a safe passenger headroom.
Take into account the required length in the design phase of the project.  

Wellway Opening

In order to install an escalator, consider a wellway with suitable width and on the lower floor. The wellway width is equal to the total escalator(s) width and the length must be design in a way that the lower section of the truss can be located beneath the surface of the lower floor. As a result, the escalator floor plate will be at the same level as the lower floor finished surface.
Take into account the required length in the design phase of the project.
How do you rate this article?
2 replies

Leave a Reply

Leave a Reply

Your email address will not be published. Required fields are marked *

© Copyright 2020 - La Grazia Srl | Escalator & Moving Walk Company

Please Wait ...

It May Take a Few Minutes